Operation Manual

8.2 Installing the LX8000
Prepare the cut-out in the instrument panel according to the drilling template. For best
viewing angle consider installing the LX8000 into position which will meet requirements
shown on picture below.
Position the LX8000 digital unit in the cut-out in the instrument panel. Tighten the LX8000
digital unit with attached 2.5 mm screws.
When installing the LX8000 it is not necessary to remove the rotary knobs.
The mounting template is shown in the picture below (not to scale!):
The V5 vario unit should be mounted in a standard 57 mm hole.