Operation Manual

Press the CHAR>> button and the cursor will move to the second letter. Use the lower-
right knob to select the second letter. If you want to return to the first letter turn the lower-
left knob anticlockwise.
Repeat this procedure until your desired point is selected. Press the SELECT button to
complete this selection. If you do not know exact name of a point just select the first letter
and press the SELECT button. Now scroll to the desired point using the lower-right knob.
Press the SELECT button once more to complete this selection.
The task edit dialogue should now look like the screen below. The letter “S” indicates you
entered the start point.
Move the cursor down to the next empty point and repeat the above procedure until the
entire task is entered.
5.7.3 Modifying Zones
Now it is time to modify the observation zones. Select a point and press the ZONE button.
A new dialogue with the observation zone for the selected point will open.
Using parameters in the zone dialogue it is possible to describe all types of observation
zones. Angle12 defines the orientation of the observation zone. Available parameters for
Direction are:
• Symmetric: the most common selection for a turn point.
• Fixed: mostly used for assigned areas.