Operation Manual

FlarmView Version 1.01 November 2013
Page 17 of 21
5 Installation
5.1 Installing the LXNAV FlarmView
The LXNAV FlarmView cutout is very simple. A square hole with dimensions 14mm x 15mm,
need to be cut.
Peel off protection film and stick FlarmView to the instrument panel.
5.2 Installing the FlamView57
The FlarmView57 is installed in one standard 57mm (2,5’’) cutout. If there is none, prepare it
according to the picture below.
The length of the M4 screws is limited to 6mm!!!!
2 1/4 “
φ
φφ
φ
57mmh11
φ
φφ
φ
66.0mm
4
,5
mm
6mm