Operation Manual

FlarmLed display Version 1.0 August 2013
Page 8 of 13
4.4 Setting up FlarmLed display
If we hold push button, during power on, LXNAV FlarmLed will go in setup mode, where is
possible to adjust following settings:
• Communication speed
• Master/Slave mode
Yellow led indicates mode that we are setting, Red leds indicates setting of each mode.
Red 12 Red 1 Red 2 Red 3 Red 4 Red 5
Yellow 12 Baudrate 4800bps 9600bps 19200bps 38400bps 57600bps 115200bps
Yellow 1 Maste/Slave Master Slave / / / /
This setup is prepared because some flarms are set to different baudrates, so it’s necessary
also to set FlarmLed to same baudrate. Normally Flarm default baudrate is 19200bps, on
that setting is also set FlarmLed display. Master/Slave option is usable only if we have
connected to flarm more than one Flarm led display. Tin that case display can interferr each
other. Only one can be set to Maste, all other must be set to slaves.
4.5 Error codes from flarm
Error code
Description
Functionality
Display
0x11
Fault: Software out of date
(needs GPS reception)
No operation
0x12
Fault: Software integrity
violation
(only on IGC-units)
No operation
0x21
Fault: Low Voltage
No operation
0x31
Fault: Internal GPS
communication
No ope
ration
0x32
Fault: Faulty GPS
configuration
No operation