Operation Manual

FlarmLed display Version 1.0 August 2013
Page 7 of 13
4.1.3 Vertical direction LEDs
5 LEDs are describing vertical angle of threat divided by 14°
4.1.4 Push Button
With push button we can adjust volume of beep, turning on/off near mode or adjust initial
settings of FlarmLed display.
4.2 Normal operation
In normal operation with short press, we can cycle between three different volumes (Low,
Medium and High). With long press, is enabled or disabled near mode. Switching of mode is
also visually supported with moving light around circle. Red moving light means, that near
mode is enables, Yelow moving light means, that near mode is disabled.
4.2.1 Near mode
near mode is possible also observe traffic, which is not dangerous for us. We will see it in
orange color and quiet. If near mode is off, only warnings will be displayed (Warmings where
is possibility of collision).
4.3 Powering up FlarmLed display
LXNAV FlarmLed is powered directly from flarm device with 3.3Volts. When gets power it
passes bootup sequence with test of all LEDs and short beep, shows version of FlarmLed
dispay firmware (yellow led indicated major version, red indicates minor version).