Manual

R.E.P.R. MANUAL
LWRC INTERNATIONAL
64
65
7.0 TROUBLE SHOOTING
NOTE: When shooting with a silencer or suppressor please note the
following:
7.1 Follow Manufacturer’s instructions for mounting/
dismounting suppressor, for care and use.
7.2 Use suppressor design with same caliber of weapon.
7.3 Ensure suppressor is rmly attached prior to use.
7.4 Cyclic Rate will be increased.
7.5 Gas/fouling will be increased.
7.6 Weapon shall require an increase in lubrication and cleaning.
7.7 If running a suppressor for an extended period, or if the
situation permits, turn the Gas Regulator to the Suppressed (S)
setting.
Failure to Load
CAUSE CORRECTION
Bent/damage magazine feed lips or
Worn/Weak magazine feed spring
Inspect Magazine and replace as
necessary
Worn out/under powered recoil spring Replace spring. Do not try to stretch.
Under powered ammunition (Cause-
Short Stroke)
Use SAAMI, CIP or NATO Spec.
Ammunition
Leading of feed ramps from use of Non-
FMJ (Full Metal Jacket) ammunition
Disassemble and clean feed ramps and
use jacketed ammunition
Failure to Lock
CAUSE CORRECTION
Wrong ammunition for chamber
Use proper SAAMI/CIP/ NATO Spec.
Ammunition.
FOD (Foreign Object Detected) in
chamber or barrel extension
Disassemble and clean rie.
Ammunition defective/damaged or out
of specication
Inspect all ammunition prior to use and
ensure SAAMI/CIP/NATO compliant.
Weak/worn Buer/Action Spring Replace spring.
Failure to Fire
CAUSE CORRECTION
Defective ammunition/dead primer
Inspect all ammunition prior to use and
ensure SAMI/NATO compliant.
Broken/weaken hammer spring Replace spring.
FOD (Foreign Object Detected) in Pin
Channel (Fire Control Group)
Disassemble and clean.
Worn Firing Pin Replace ring pin
Carrier Bounce/Bolt Bounce
Adjust Gas Regulator to smaller setting.
Use lower pressure ammunition.
Foreign Objects & Debris (FOD) in Fire
Control Group (FCG)
Disassemble and clean.