Manual

R.E.P.R. MANUAL

LWRC INTERNATIONAL

6.2.5 Piston Operating Group Disassembly

6.2.5a To disassemble the Piston Operating Group assembly, grasp

the front of the operating rod and pull rmly to the rear compressing

the piston spring while pulling forward on the Piston Cup (Fig. 6r).

Ensure to pull it straight back into the receiver or it will bind. The

front of the operating rod will disengage from the piston cup.

NOTE: If disassembling only the gas piston components on an

otherwise assembled rie, lock the bolt to the rear while disas-

sembling or assembling the gas piston components to relieve

the recoil spring resistance.

6.2.5b Lift out the front of the operating rod assembly and pull it

forward then away from the receiver. (Fig. 6s)

Fig. 6R: Grasp cup and pull back on Piston Rod

6.2.5c Pull the piston cup to the rear and o of the nozzle. This

completes detailed disassembly.

6.3 ASSEMBLY

Assembly of the R.E.P.R. series is accomplished by reversing the

disassembly steps. During reassembly take note of the following:

6.3.1 When reinstalling the Operating Rod Assembly, rotate the

Assembly until it fully seats in the Piston Cup.

6.3.2 When reinstalling the Buer and Buer Spring, push the

Buer fully past the buer detent and ensure it is captured behind

the detent.

6.3.3 When reinstalling the Extractor, line up the holes by pressing

rmly on the center of the Extractor while reinstalling the extractor

pin.

Fig. 6S: Pull Piston Rod forward and clear