Manual

R.E.P.R. MANUAL
LWRC INTERNATIONAL
34
35
4.2 LOADING A WEAPON IN CONDITION 4
Starting with the weapon in Condition 4:
4.2.1 Insert a loaded magazine rmly into the Magazine Well.
Ensure the magazine is fully seated by tugging on it.
4.2.2 Charge the weapon by rmly pulling the charging handle to
the rear and releasing it (“slingshot” method).
4.2.3 Rotate the selector to “SAFE”. If not immediately ring
the weapon close the ejection port cover. The Weapon is now in
Condition 1.
4.3 FIRING IN SEMI-AUTOMATIC MODE
Starting with a weapon in Condition 1:
4.3.1 Bring Weapon to the “Ready” position.
4.3.2 Acquire and Aim at the intended Target.
4.3.3 Put Selector to “SEMI”.
4.3.4 Depress trigger with a deliberate squeezing motion of the
strong hand index nger to re individual shots. Repeat until target is
neutralized.
4.3.5 Scan and assess for threats or targets.
4.3.6 Put Selector to “SAFE”.
4.3.7 Close Ejection Port Door.
4.0.1 Choice of Ammunition
Although the R.E.P.R. is designed to cycle with a broad spectrum of
ammunition, it is optimized for use with heavy bullet loads. With a
1-in-10 inch rate of riing, the barrels are designed to stabilize heavy
bullets up to 190 grains.
The design ammunition is M118LR Match ammunition with the 175
grain Sierra Match King bullet. The factory recommends the use of
this ammunition or similar loads such as the Federal Gold Medal
Match (GMM) and Black Hills 175gr Match. It is suggested to use
ammunition with bullets heavier than 168 grains for peak accuracy.
M80 Ball and equivalent will not realize the true accuracy potential
of the R.E.P.R. It is not suggested you use M118LR or any long range
load in SBR’s. The slow burn rate of these propellent is not optimized
in short barrels. Reliability and velocity will be adversly aected
4.0.2 Magazines
The R.E.P.R. was designed to use common magazines with other
7.62x51mm NATO ries currently in use. However, the R.E.P.R. is
optimized and will perform best with the supplied Magpul LR-20
magazine. Additional magazines are available from LWRCI.
4.1 LOADING A MAGAZINE
4.1.1 Grasp the Magazine rmly in your support hand.
4.1.2 Push the round under the magazine feed lips. The base
of the cartridge should be all the way back against the back of the
magazine.
4.1.3 Repeat until the magazine is lled. DO NOT OVERFILL the
magazine.