Manual
R.E.P.R. MANUAL
32
OPERATION
3.5.5 Re-assemble the weapon inserting the Bolt Carrier Group.
Pivot the Lower Receiver back up to the Upper Receiver and press in
the Rear Take Down Pin.
3.5.6 Ensure that the Gas Regulator is in the appropriate detent
position as dictated by use.
3.5.7 Inspect the Magazines for the following: Ensure the
Magazines are clean and not dented (particularly the feed lips).
Ensure the Magazine Follower moves freely within the magazine
body and returns under its own spring tension without binding.
Do NOT oil or otherwise lubricate magazines. Only use Magazines
recommended by LWRCI.
3.5.8 Inspect the ammunition prior to ring. Ensure ammunition
is factory manufactured in compliance with SAAMI, CIP and/or U.S.
MIL-Spec/STANAG specications. Ensure ammunition is the correct
caliber for the weapon. Ensure ammunition is clean. Do not oil or
otherwise lubricate ammunition. Do not overload magazines.
3.5.9 Put the weapon in Condition 4 or Range Safe status.
33