Manual

R.E.P.R. MANUAL
LWRC INTERNATIONAL
30
31
3.4B AUTOMATIC MODE
3.4.10 Place the selector lever on “AUTO” Depress and hold the
trigger. The hammer should fall.
3.4.11 Continue to hold the trigger and charge the weapon 2-3
times. Each time the bolt should go forward and the hammer should
fall. Release the trigger.
3.4.12 This completes the function check. Make weapon
Condition 4.
3.5 PRE-FIRE INSPECTION (PFI)
Perform the following inspection prior to each ring session. Start
your PFI with your weapon in Condition 4.
3.5.1 Break the weapon down “shotgun style” by pulling out the
Take Down Pin (26.) and pivoting the Lower Receiver down from the
Upper Receiver.
3.5.2 Remove the Bolt Carrier Group by pulling the Charging
Handle back all the way and grasping the rear of the Bolt Carrier.
3.5.3 Inspect the Bolt and Bolt carrier ensuring the following; the
Bolt Cam Pin is correctly installed with the arrow facing forward; if
applicable, the Firing Pin Retainer is fully seated in its hole. Ensure the
ring pin hole is unobstructed and the Firing Pin is properly installed.
Tap the bottom of the Bolt Carrier rmly against the palm of your
hand. The Firing Pin should stay in place.
3.5.4 Visually inspect the bore of the weapon to ensure it is
unobstructed. In low light conditions physically inspect the bore by
passing a cleaning rod through it.
3.4.2 Insert an empty Magazine fully into the Magazine Well
and pull downward. The Magazine should remain locked into the
magazine well.
3.4.3 Grasp the Charging Handle and pull it rmly to the rear. The
bolt carrier should lock to the rear. Return the charging handle to its
forward and locked position by pushing it forward.
3.4.4 Depress the magazine release. The magazine should eject
from the magazine well and the bolt carrier should remain locked to
the rear.
3.4.5 Depress the top serrated portion of the bolt catch. The bolt
carrier should spring fully forward and lock into battery.
3.4.6 With the selector lever on “SAFE” depress the trigger. The
hammer should not fall.
3.4.7 Rotate the selector lever to “SEMI” and depress the trigger.
The hammer should fall.
3.4.8 Charge the weapon by grasping the charging handle,
pulling it rmly to the rear and releasing. Depress and hold the
trigger. The hammer should fall.
3.4.9 Continue holding the trigger while charging the weapon
again. Release the trigger as slowly as possible and you should hear
a click as the disconnector disengages. The hammer should remain
cocked.