Manual

R.E.P.R. MANUAL
LWRC INTERNATIONAL
28
29
3.3.5 Roll the rie counterclockwise to visually conrm that there
is no round or casing in the chamber. If light conditions are low,
physically inspect chamber.
3.3.6 Upon conrmation that the chamber is clear, depress the
paddle of the Bolt Catch. The bolt carrier should move forward and
go into battery.
3.3.7 While pointing the weapon in a safe direction, depress the
Trigger to render it inert. Your Selector Lever should not go to safe,
indicating that the hammer is no longer cocked.
3.3.8 Close the Ejection Port Cover. Your rie is now in Condition 4
and ready for administrative handling.
CAUTION: Do not depend on the fact that no
chambered round was ejected on clearing. You
can still have a live round in the chamber that
did not extract/eject because your extractor was
broken, or if the case rim was ripped through by
the extractor. VISUALLY AND PHYSICALLY inspect
the chamber to ensure it is clear.
3.4 PRE-FIRE FUNCTION TEST:
The User should always complete a pre-re function test of the action
and re control group before using the weapon and any time the
weapon has been disassembled and reassembled.
3.4a Semi-Automatic Mode
3.4.1 Ensure weapon is CLEAR (see 3.3) and in Condition 4 prior to
performing a function test.
3.2 WEAPON CONDITIONS:
Condition 4: Bolt forward on an empty chamber, ejection
port cover closed, no magazine inserted, and selector lever
on re (will not engage safe). See 3.3
Condition 3: Bolt forward on an empty chamber, ejection
port cover closed, magazine inserted, and selector lever on
re (will not engage safe).
Condition 2: Not applicable.
Condition 1: Bolt forward with a round chambered, ejection
port cover closed, magazine inserted, and selector lever on
safe.
Range Safe: Bolt locked to the rear, ejection port cover
open, no magazine inserted, and selector lever on safe.
3.3 CLEARING YOUR WEAPON – UNLOADING:
3.3.1 Ensure the muzzle is pointed in a safe direction at all times
and through the course of unloading the weapon.
3.3.2 Remove the Magazine (if present) by depressing the
Magazine Release and either allowing it to drop free or pulling it out.
3.3.3 Depress and hold the base of the Bolt Catch with trigger
nger.
3.3.4 Grasp the Charging Handle rmly with the support hand
and pull rmly all the way to the rear. Release the Charging Handle.
The bolt carrier should remain locked back.