Manual

R.E.P.R. MANUAL
LWRC INTERNATIONAL
16
17
CAUTION: Adjusting the trigger to a very low
pull weight can cause a signicant safety issue
on a self-loading rie. LWRCI does not suggest
you adjust the trigger. It has been factory tuned
on a precision jig.
CAUTION: LWRCI only advocates the use of the re
control group supplied with your weapon. They
have been thoroughly tested through drop testing
and environmental testing to ensure safe use in the
eld. There are single-stage match triggers on the
market that, in our opinion, are unsafe for use on an
operational rearm.
CAUTION: Installation of aftermarket accessories
that extend into the trigger guard area of the
weapon is discouraged and could result in a
negligent discharge.
2.1.6.3 CHARGING HANDLE (8.)
The Charging Handle on the left side of the R.E.P.R. is used to
charge the weapon and/or retract the Bolt Carrier Group. It is non-
reciprocating. A Forward Assist or Silent Bolt Closure is built into the
Charging Handle and is activated by depressing the Charging Handle
Knob and pushing forward.
NOTE: Depressing the Charging Handle knob while charging a
R.E.P.R. will prevent the Bolt carrier Group from retracting fully
and potentially cause a misfeed.
2.1.6.4 BOLT CATCH/RELEASE (17. AND 25.)
The R.E.P.R. is equipped with ambidextrous bolt catch/release
2.1.6 OPERATING CONTROLS
2.1.6.1 SELECTOR LEVER (14.)
Located on the left side of the lower receiver, the selector lever
functions as the manual safety of the R.E.P.R. and also the re
control selector on select re weapons. The receiver is marked with
pictograms of all three modes,
SAFE Prevents trigger from releasing
the hammer.
SEMI-AUTOMATIC Allows one shot per pull of the
trigger.
AUTOMATIC Rie will shoot and load multiple
shots until the trigger is released
or ammunition runs out.
ALL LWRCI ries are marked with the AUTOMATIC setting, however
it is only functional in a select-re weapon (Military and Law
Enforcement Only). The AUTOMATIC setting cannot be engaged in a
semi-automatic weapon.
SAFE can only be engaged when the hammer is cocked by oper-
ating the charging handle.
2.1.6.2 TRIGGER (15.)
The Trigger is used to re the weapon. It is enclosed by the Trigger
Guard. The R.E.P.R. 18 is equipped with a 2-stage trigger. It has a
heavier and longer 1st stage (approx. 4lbs pull) and a lighter, crisp
2nd stage break (approx. 1 lb. pull). The R.E.P.R. 20 is equipped
with an adjustable, 2-stage trigger. Please follow the instructions,
provided by Geissele Automatics, for adjusting the trigger.