Manual

14
2.1 – Pre-Fire Function Test
e user should always complete a pre-fire function test of the action and fire control
group before using the weapon and any time the weapon has been disassembled and
reassembled.
Semi-Automatic Mode
1. Ensure weapon is clear and in Condition 4 prior to performing functions check.
2. Insert an empty magazine fully into the magazine well and pull downward. e magazine
should remain locked into the magazine well.
3. Grasp the charging handle and pull it firmly to the rear. e bolt carrier should lock to the
rear. Return the charging handle to its forward and locked position by pushing it forward.
4. Depress the magazine release. e magazine should eject from the magazine well and the
bolt carrier should remain locked to the rear.
5. Depress the top serrated portion of the bolt catch. e bolt carrier should spring fully
forward and lock into battery.
6. With the selector lever on “SAFE” depress the trigger. e hammer should not fall.
7. Rotate the selector lever to “SEMI” and depress the trigger. e hammer should fall.
8. Charge the weapon by grasping the charging handle, pulling it firmly to the rear and
releasing. Depress and hold the trigger. e hammer should fall.
9. Continue holding the trigger while charging the weapon again. Release the trigger and you
should hear a click as the disconnector disengages. e hammer should remain cocked.
Automatic Mode
1. Place the selector lever on “AUTO” Depress and hold the trigger. e hammer should fall.
2. Continue holding the trigger and charge the weapon 2-3 times. Each time the bolt should
go forward and the hammer should fall. Release the trigger.
is completes the functions check. Make weapon Condition 4.