Full Product Manual

Spa Operational Modes:
Once the spa is powered on you can press and hold the program button for
three seconds to change the spa’s operational mode.
The spa has three operational modes.
Standard Mode is the default operational mode which allows all functions of the spa to work.
Standard mode should be used when the spa is being occupied. The LCD will display an “N”
at the bottom when in Standard Mode.
Economy Mode is a power saving mode that is used when the spa is not being occupied.
Economy mode uses the pre-programmed heating and water circulation time to maintain the
spa when not in use. Anti-freeze protection is also active while in Economy mode. The LCD
will display an “E” at the bottom when in Economy mode.
Sleeping Mode: While in Sleeping mode, the spa control functions will not be active except
the anti-freezing protection. The anti-freezing protection will turn the heater on automatically
when the temperature drops below 6℃43). Once the water temperature reaches 10
(50℉, the heater function will turn off automatically. The LCD will display “D” in Sleeping
mode.
Keypad Buttons:
1 Water Pump 1
1.1 When the control system is on, pressing the pump 1 button will turn the pump on.
If the pump is configured as a single-speed pump, pressing this button again will
turn the pump off. Depending on the model, if Pump 1 is configured as a two-speed
pump, pressing this button will change the pump from low speed to high speed and
turn it on and off.
1.2 Pump 1 will automatically shut down after running for 60 minutes.
Luxury Spa USA
Page 19
Call us at 866-220-7405