User's Manual

Simply Connected

Other trademarks and registered trademarks are the property of their respective owners

WPS CONFIGURATION/RESET BUTTON

Used to conﬁgure WPS (Wi-Fi Protected Setup) or restore factory default settings

To conﬁgure WPS, press and hold the WPS/Reset button until the WPS LED

turns on (typically about 5 seconds). The XWR-600 is now in WPS pairing

mode. Follow the pairing instructions for your client device and enter the

XWR-600 WPS pin number (12345678) when prompted.

CAUTION: Holding the WPS button longer than 10 seconds will result

in a factory reset

CAUTION: For optimal security, it is recommended to disable WPS

after your client devices have been conﬁgured.

To reset to factory defaults, press and hold the WPS/Reset button until the

System LED stops ﬂashing (approximatly 20 seconds). A factory reset will take

one minute or more to complete. A successful factory reset is indicated when

all of the Port LEDs ﬂash once. When the System LED starts ﬂashing again the

unit is ready.

CAUTION: Resetting the XWR-600 to factory defaults will remove all

custom settings.

NOTE: To hard reboot the router, remove the power adapter. Wait 10

seconds and re-apply power.

ADVANCED SETTINGS

For login and advanced settings information go to luxul.com