User's Manual

Information on this document supersedes all previous versions. Products and documents

subject to change without notice. Products may be discontinued without notice.

LUX-QIG-XWR-1750

085130538

14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685

luxul.com | 801-822-5450

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential instal-

lation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one of the following measures:



Reorient or relocate the receiving antenna.



Increase the separation between the equipment and receiver.



Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.



Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modiﬁcations not expressly approved by the

party responsible for compliance could void the user’s authority to operate this

equipment.



This transmitter must not be co-located or operating in conjunction with any

other antenna or transmitter.

Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated

with minimum distance 20cm between the radiator & your body.

NOTE: (1)The manufacturer is not responsible for any radio or TV

interference caused by unauthorized modiﬁcations to this

equipment.(2) To avoid unnecessary radiation interference, it is

recommended to use a shielded RJ45 cable