User's Manual

Fold Fold Fold
5
Advanced Configuration
Configuring the XWR-1200 as a Wireless Controller
The XWR-1200 can manage up to two additional access points to enable
wireless client roaming and simple configuration. To enable this feature,
ensure one or two compatible access points are connected to the same
network as the XWR-1200, then select Wireless Controller from the XWR-
1200 web configuration interface. Follow the online help to add the access
point(s) to the profile.
XWR-1200 as a Controller
Other Advanced Configuration
For more information on configuring advanced features such as DDNS,
VPN, etc., refer to the support resources at luxul.com.
6
Hardware Operation
XWR-1200 Front Panel LED Indicators
Indicator Name Status Function
5GHz ON A 5GHz wireless network is
broadcasting.
2.4GHz ON A 2.4GHz network is broadcasting.
1-4 LED ON A device is connected to the
corresponding Ethernet port.
FLASHING Data packets are being transmitted
to the connected device.
Internet
LED
ON
XWR-1200 is connected to the ISP.
FLASHING Data packets are being transmitted
USB
LED
ON A USB-enabled device is connected
and configured.
System
LED
ON
The XWR-1200 is booting.
FLASHING
The XWR-1200 is operating normally.
OFF
The XWR-1200 is not booting.
Power
LED
ON
Power is applied to the XWR-1200.
OFF
Power is not applied to the
XWR-1200.
Front Panel
XWR-1200 Front Panel View
Rear Panel
XWR-1200 Rear Panel View

Antenna Ports: 4 RPSMA female antenna ports to connect the
included antennas.
n NOTE: All four antennas should be installed prior to powering up
the XWR-1200 and are required for optimal performance.

Power Input: Power adapter included.
n NOTE: To reboot the router, disconnect the power adapter,
wait 10 seconds and reconnect the power adapter.

WAN Port: (1) black RJ-45 Ethernet Port for Internet connection.

LAN 1 - 4 Ports: (4) green RJ-45 Ethernet ports for connecting to the
local network.
n NOTE: A Luxul switch is recommended in conjunction with the
XWR-1200 to increase the number of local ports available.

Reset Button: Used to restore factory default settings.
c CAUTION: Holding the Reset button longer than 10 seconds will
result in a factory reset.
To restore factory defaults, press and hold the Reset button until the
System LED stops flashing (approximatly 20 seconds). A factory reset
will take one minute or more to complete. A successful factory reset is
indicated when all of the Port LEDs flash once. When the System LED
starts flashing again, the unit is ready.
c CAUTION: Resetting the XWR-1200 to factory defaults will remove
all custom settings.