User's Manual
Fo ld Fo ld Fo ld
Health and Safety Recommendations
Warnings for the use of Wireless Devices: Please observe all warning notices with
regard to the use of wireless devices
Potentially Hazardous Atmospheres: You are reminded of the need to observe
restrictions on the use of radio devices in fuel depots, chemical plants, and other
similar areas where the air contains chemicals or particles (such as grain, dust, or
metal powders).
Safety in Hospitals: Wireless devices transmit radio frequency energy and may
aect medical electrical equipment. When installed adjacent to other equipment, it
is advised to verify that the adjacent equipment is not adversely aected.
RF Exposure Guidelines
Safety Information: The device complies with internationally-recognized standards
covering human exposure to electromagnetic fields from radio devices.
Warning: Exposure to Radio Frequency (RF) Radiation:
The radiated output of this device is below FCC radio frequency exposure limits.
Nevertheless, the device should be used in such a manner that the potential for
human contact during normal operation is minimized.
X
The end user must avoid any extended human RF exposure directly in front of the
device, up to a distance of 40cm, when the unit is on.
X
When servicing the equipment and selecting a location for the antennas, it
is important to note that a minimum distance of 40cm is required between
personnel and the device or antenna, to comply with radio frequency
exposure limits.
X
The antenna used for this transmitter must be installed to provide a separation
distance of at least 40cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.
The following safety precautions should be observed:
X
Do not touch or move the antenna while the unit is transmitting or receiving.
X
Do not hold any component containing the radio such that the antenna is very
close or touching any exposed parts of the body, especially the face or eyes,
while transmitting.
X
Do not operate the radio or attempt to transmit data unless the antenna is connected;
this behavior may cause damage to the radio.
ErP Statement
The purpose of this product is to create a constant network connection for your devices.
It does not have a standby mode or use a power management mode. If you wish to power
down this product, please unplug it from the power socket.
Industry Canada
This device complies with Industry Canada licence-exempt RSS-247 standard(s). Operation
is subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR-247 d’Industrie Canada applicables aux appa-
reilsradio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en comprom-
ettre le fonctionnement.
The device meets the exemption from the routine evaluation limits in section 2.5 of
RSS-102 and compliance with RSS-102 RF exposure; users can obtain Canadian information
on RF exposure and compliance.
Le dispositif rencontre l’exemption des limites courantes d’évaluation dans la section 2.5 de
RSS-102 et la conformité à l’exposition de RSS-102 rf, utilisateurs peut obtenir l’information
canadienne sur l’exposition et la conformité de rf.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. This equipment should be installed and operated with a minimum
distance of 40 centimeters between the radiator and your body.
Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu’aucune
autre antenne ou émetteur. Cet équipement devrait être installé et actionné avec une
distance minimum de 40 centimètres entre le radiateur et votre corps.
Caution:
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems;
(ii) the maximum antenna gain permitted for devices in the band 5725-5850 MHz shall be
such that the equipment still complies with the e.i.r.p. limits specified for point-to-point
and non-point-to-point operation as appropriate.
Avertissement:
(i) les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement
pour une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux
systèmes de satellites mobiles utilisant les mêmes canaux;
(ii) le gain maximal d’antenne permis (pour les dispositifs utilisant la bande de 5725 à 5850
MHz) doit être conforme à la limite de la p.i.r.e. spécifiée pour l’exploitation point à point
et l’exploitation non point à point, selon le cas;
CAN ICES-3( )/NMB-3( )
Simplified EU declaration of conformity
Hereby, Luxul declares that the radio equipment type is in compliance
with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet
address: http://luxul.com/regulatory-compliance
Le soussigné, Luxul, déclare que l’équipement radioélectrique du type est
conforme à la directive 2014/53/UE.
Le texte complet de la déclaration UE de conformité est disponible à l’adresse internet
suivante: http://luxul.com/regulatory-compliance
Hiermit erklärt Luxul, dass der Funkanlagentyp der Richtlinie 2014/53/EU
entspricht.
Der vollständige Text der EU-Konformitätserklärung ist unter der folgenden
Internetadresse verfügbar: http://luxul.com/regulatory-compliance
Hierbij verklaar ik, Luxul, dat het type radioapparatuur conform is met
Richtlijn 2014/53/EU.
De volledige tekst van de EU-conformiteitsverklaring kan worden geraadpleegd op het
volgende internetadres: http://luxul.com/regulatory-compliance
XWO-BAP1
XWO-BAP1
XWO-BAP1
XWO-BAP1
B B