User's Manual

REGULATORY COMPLIANCE AND SAFETY NOTIFICATION
This documentation contains regulatory compliance and safety information for both wireless and non-wireless hardware. Not
all the information contained in this document applies to every product.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Regulatory Compliance
The device complies with internationally recognized standards covering human exposure to electromagnetic fields from radio
devices. This equipment also complies with FCC radiation exposure set forth for an uncontrolled environment. In order to avoid
the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 30cm
(11.8 in) during normal operation.
Unauthorized antennas, modifications, or attachments could cause damage and may violate regulatory approvals. Any
changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate
the equipment.
Luxul equipment marketed in the U.S. is restricted to usage of channels 1-11 only for 2.4GHz and channels 100-140/149-165 for
5GHz.
FCC Statement—Wireless FCC 2.4GHz & 5GHz 802.11b/g/n/ac
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for either a Class A or Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communi-
cations. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Refer to included Quick Installation Guide for device-specific FCC Class information.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate this equipment.
f
This device complies with part 15 of the FCC Rules.
f
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm (8in) between the radiator & your
body.
Warnings and Safety Information
f
Verify that the electrical circuits have appropriate grounding and overload protection.
f
Attach only approved power cords to the device.
f
Verify there is adequate ventilation around the device, and that ambient temperatures meet equipment operation
specifications.
f
DO NOT install in or near hot or humid places, such as a kitchen or bathroom. Take care to minimize exposure to excessive
heat or moisture.
f
Small parts and plastic bags used for packaging may be harmful to small children. KEEP ALL ACCESSORIES OUT OF THE
REACH OF CHILDREN!
f
This product may become hot when in use for extended time periods. This is normal and is not a malfunction. DO NOT
install where it will be exposed to paper, cloth or other flammable materials.
Health and Safety Recommendations
Warnings for the use of Wireless Devices: Please observe all warning notices with regard to the usage of wireless devices
© 2015 Luxul. All Rights Reserved. LUX-REG-FCCSAFETY-alpha 09161502
pg j y
Radiation Ex
p
osure Statemen
t
This equipment complies with FCC radiation exposure limits set forth for an uncontrolle
d
This
equipment
complies
with
FCC
radiation
exposure
limits
set
forth
for
an
uncontrolled
e
nvironment. T
h
is equipment s
h
ou
ld
b
e insta
ll
e
d
an
d
operate
d
wit
h
minimum
d
istance 20cm (8in)
b
etween t
h
e ra
d
iator & your
b
o
d
y.
y
y
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
T
his equipment has been tested and found to comply with the limits for either a Class A or Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
T
his equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.