User's Manual

User Guide
12
© Copyright 2011 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
Indicator Name Description
WLAN Status
On The wireless radio is active and wireless
access is enabled an active connection to the
internet
Off The wireless radio is not active and wireless
access is disabled
LAN Link/Activity
On There is an active Ethernet connection
Flashing Indicates Ethernet activity
Off There is no active Ethernet connection
Power
On The power is on
Off No power, check power connections
At startup, the Green Power LED will stay on while the amber LAN Link light
flashes. The blue LED will come on once the XAP-1040 radio is active.
Reset Button:
The Reset button is used to clear the current settings of the XAP-1040 and restore
factory default settings.
To Restore the Default Settings: With the XAP-1040 powered on, press and hold
the Reset button for 10 seconds. When the Power LED comes on again, release the
reset button. The XAP-1040 will be set to factory defaults.
CAUTION: Pressing and holding the Reset button will remove any
custom configurations done to the XAP-1010.
4.5 Environmental Requirements
X
Ethernet cable to provide Power and Data to the XAP-1040.
X
A computer supporting TCP/IP and equipped with a Web browser. Supported
Web browser versions include Microsoft IE 7.0 and up, Safari 1.0 and up, Mozilla
Firefox 1.0 and up, and Google Chrome 5.0 and up. The Web browser is used to
configure the XAP-1040.
X
The XAP-1040 uses 36-57VDC power. The POE injector power supply requires AC
100V ~ 240V, 50Hz ~ 60Hz.
X
Temperature of the operating environment: -4F~131F (-20C to 55C). Be sure to
place the access point away from heat generating devices.