User's Manual

luxul.com | 357 South 670 West | Suite 160 | Lindon, UT 84042 | p: 801-822-5450 | f: 801-822-5460
User Guide
11
CAUTION: When lifting the base, be careful not to pull, bend or
otherwise move the base or cover excessively. By simply
lifting the base slightly, you should be able to see the LEDs
as well as access the Reset button. When re-assembling the
unit, be sure to maintain the weather-resistant integrity of
the enclosure by verifying that the rubber seal is properly
seated and the four screws are firmly in place, but not
over-tightened.
With the base lifted to the right, System LEDs and the Reset button can be seen as
shown here:
Reset
Button
Reset Button and LED Location
Status Indicators:
With the unit facing down and the base moved to the right as shown above, the
XAP-1040 has four LEDs, positioned horizontally on the bottom, left side of the
board. When viewed left to right, LEDs are as follows: 1) Bridge Mode (Green); 2)
WLAN Status (Blue); 3) LAN Link/Activity (Amber); and 4) Power (Green).
The following table describes the LED functionality:
Indicator Name Description
Bridge Mode
On Bridge Mode is enabled
Off The AP is in default “Access Point” mode.