User's Manual

User Guide
8
© Copyright 2011 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
3.3 Safety Information
To maintain the safety of users and property, follow these safety instructions:
X
The XAP-1031/1032 wireless access point is designed for indoor use only. DO
NOT place this access point outdoors. If you require an outdoor access point,
please consider the Luxul XAP-1040.
X
DO NOT install this access point in or near hot or humid places, such as a kitchen
or bathroom. Take care to minimize exposure to excessive heat or moisture.
X
DO NOT pull any connected cable with force. When disconnecting cables, do so
by disconnecting first from the access point. When reconnecting, connect the AP
first and then the Power/data source.
X
When installing the access point, be sure it is firmly secured.
X
Accessories of this access point, such as mounting screws, the POE injector and
power supply may be dangerous to small children under 3 years of age. KEEP All
ACCESSORIES OUT OF THE REACH OF CHILDREN!
X
The access point may become hot when in use for extended time periods. This is
normal and is not a malfunction. DO NOT install this access point where it will
be exposed to paper, cloth or other flammable materials. If not using the electri-
cal box included with the unit, ALWAYS use a properly shielded and UL listed
electrical box for installation.
X
The XAP-1031/1032 contains no user-serviceable parts. If the access point is not
working properly, contact your dealer and ask for help. DO NOT attempt to
disassemble the access point.
4 HARDWARE FEATURES AND INSTALLATION
The XAP-1031/1032 high powered access point is designed for optimal perfor-
mance as well as for simple and efficient installation and setup. It implements two
Luxul circular polarized directional antennas. For optimal performance, antennas
should be placed in a location that allows the antennas to be “pointed” towards
the desired coverage areas and in such a way that signal overlap between the two
antennas is minimal. Installation can be directly on a wall or discreetly in an attic,
above ceiling tiles or other non-public area. The XAP-1031/1032 is ideal for use in
L-shaped, multi-wing or very large residential or commercial installations.
4.1 Front View
On the front of the XAP-1031/1032 are 4 LEDs. LEDs indicate 1) Power, 2) LAN Link/
Activity, 3) WLAN Status and 4) Bridge Mode.