User's Manual

User Guide
20
© Copyright 2011 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
NOTE: It is recommended to use a strong password containing:
w
More than the minimum number of characters
w
One or more capital letters
w
Numbers and/or special characters
X
Administrator Login: Sets the password for Administrator access to the
XenSmart™ web management interface. When connecting to the Access Point
through the XenSmart™ web interface, the user is prompted for a User ID (this is
always admin) and Password (the default value is “admin”). It is HIGHLY recom-
mended to change to a secure password when initially configuring the Access
Point. To change the password, simply enter the new password, confirm the
password, then click Save, and then Reboot for the change to take effect.
After confirming the desired Quick Setup configuration settings, select Save and
then Reboot for the settings to take effect.
5.3 Wireless
5.3.1 Basic Wireless Settings
Basic Wireless Settings: This screen allows the modification of the following basic
settings for the wireless network:
X
Wireless Radio: This field is used to Enable and Disable the wireless network and is
set to Enabled by default. If the Radio is Disabled the Access Point will not broadcast
a wireless signal. To Disable the Wireless Radio, click the dropdown menu, select
Disabled, then click Save and then Reboot for the change to take effect.
X
Channel: This field allows the user to set which 2.4GHz channel to use. The
default is set to Channel 6 and is the recommended setting due to the Access
Point being optimized to run on Channel 6. However, any other channel (1-11) may
be selected. To change the Channel, click the dropdown menu, select the desired
channel, then click Save and then Reboot for the change to take effect.