User's Manual

User Guide
16
© Copyright 2011 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
4.4.8 LED Visual Verification
With power applied, you can now verify that the XAP-1031/1032 is connected and
functioning properly. Prior to placing the access point cover plate, perform a visual
inspection of the LEDs. The Green PWR LED (on the left) should be on while the
amber LAN light flashes, indicating activity. Once the XAP-1031/1032 is properly
connected to the Internet source, the blue WLAN LED should also remain on. The
Green BRG LED at the right will only be on if the access point is set to function in
bridge mode.
The LED pattern for the XAP-1031/1032 are the same
5 CONFIGURATION
5.1 Login
The XAP-1031/1032 are not equipped with internal DHCP server. If connected to
the Luxul XBR-2300 Enterprise Dual-WAN Router, configuration will be automatic.
Otherwise, the IP address of the computer for login and configuration will need
to be manually configured. The table below lists the default parameters of the
XAP-1031/1032.
Parameter Default Value
Default IP address
192.168.0.13
Default user name
admin
Default password
admin
Login to the XAP-1031/1032 Wireless Access Point with the following steps:
a. Be sure the XAP-1031/1032 is properly installed and powered on
b. Open your Web Browser, and enter http://192.168.0.13.
The login window appears as shown below: