User's Manual

User Guide
16
© Copyright 2011 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
Login to the XAP-1010 Wireless Access Point with the following steps:
a. Be sure the XAP-1010 is properly installed and powered on
b. Open your Web Browser, and enter http://192.168.0.10.
The login window appears as shown below:
c. Enter the user name and password (default user name is ”admin” and default
password is “admin”), and then click OK to login to the Quick Setup window.
5.2 Quick Setup
Quick Setup: For most installations, it is expected that the Quick Setup page will
be sufficient to optimally configure and deploy the XAP-1010 Wi-Fi network. The
Quick Setup page consists of the following:
X
DHCP Client: Enabled or Disabled. DHCP (Dynamic Host Configuration Protocol)
is used to automatically assign an IP Addresses to a device on the network. If
DHCP is enabled on the Access Point, it will no longer use the static address set
by Luxul at time of manufacturing and will request a dynamic IP Address from the
Router (sometimes referred to as the Gateway).