User's Manual

User Guide

4.4.4 Connecting to the Internet Source

The Luxul device is not a router and in most installations will be connected to a

Router or Switch in order to deliver Internet access. To do so, connect the POE

injector (or switch) to the desired Internet source using another Ethernet cable. Be

sure the source device is powered off.

Data

Source

Power

Source

Data

Power

Data/Pwr

Out

POE

Injector

The POE Injector Sends Power and Signal Over One Ethernet Cable

4.4.5 Applying Power

Once the Ethernet cables have been properly connected, connect the power sup-

ply to the POE injector and plug it in to a standard AC power outlet. Or, if plugging

into a POE switch, turn the switch (or appropriate port) on. The network source

device can also now be powered back on.

NOTE: If your Internet source (Router or Switch) is a POE enabled device

and connected via POE, it can be plugged directly into the access

point without the need to run a separate POE injector.

4.4.6 LED Visual Veriﬁcation

With power applied, you can now verify that the XAP-1010 is connected and

functioning properly. Prior to placing the access point cover plate, perform a visual

inspection of the LEDs. The Green Power LED (bottom of the stack) should be on

while the amber LAN Link light ﬂashes, indicating activity. Once the XAP-1010 is

properly connected to the Internet source, the blue WLAN LED should also remain

on. The Green LED at the top of the stack will only be on if the access point is set

to function in bridge mode.