User's Manual

luxul.com | 357 South 670 West | Suite 160 | Lindon, UT 84042 | p: 801-822-5450 | f: 801-822-5460
User Guide
11
XAP-1010 Rear View
The Reset button is used to clear the current settings of the XAP-1010 and restore
factory default settings.
Reset
XAP-1010 Reset Button Location
To Restore the Default Settings: With the XAP-1010 powered on, press and hold
the Reset button for 10 seconds. When the Power LED comes on again, release the
reset button. The XAP-1010 will be set to factory defaults.
CAUTION: Pressing and holding the Reset button will remove any
custom configurations done to the XAP-1010.
4.3 Environmental Requirements
X
Ethernet cable at the electrical box installation location to provide Power and
Data to the XAP-1010.
X
A computer supporting TCP/IP and equipped with a Web browser. Supported
Web browser versions include Microsoft IE 7.0 and up, Safari 1.0 and up, Mozilla
Firefox 1.0 and up, and Google Chrome 5.0 and up. The Web browser is used to
configure the XAP-1010.
X
The XAP-1010 uses 36-57VDC power. The POE injector power supply requires AC
100V ~ 240V, 50Hz ~ 60Hz.
X
Temperature of the operating environment: 32F~131F (0C~55C). Be sure to place
the access point away from heat generating devices.
X
Humidity of the operating environment: 5%-95% non-condensing. Do not place
the access point in an extremely dirty or damp location.