User's Manual

luxul.com | 357 South 670 West | Suite 160 | Lindon, UT 84042 | p: 801-822-5450 | f: 801-822-5460
User Guide
15
Data
Source
Power
Source
Data
In
Power
In
Data/Pwr
Out
POE
Injector
The POE Injector Sends Power and Signal Over One Ethernet Cable
4.5.5 Applying Power
Once the Ethernet cables have been properly connected, connect the power sup-
ply to the POE injector and plug it in to a standard AC power outlet. Or, if plugging
into a POE switch, turn the switch (or appropriate port) on. The network source
device can also now be powered back on.
NOTE: If your Internet source (Router or Switch) is a POE enabled device
and connected via POE, it can be plugged directly into the access
point without the need to run a separate POE injector.
4.5.6 LED Visual Verification
With power applied, you can now verify that the XAP-1020 is connected and
functioning properly by performing a visual inspection of the LEDs. When looking
through the viewing portal (facing the front of the unit), the Green Power LED at
the right should be on while the amber LAN Link light flashes, indicating activity.
Once the XAP-1020 is properly connected to the Internet source, the blue WLAN
LED should also remain on. The Green LED at the the left will only be on if the
access point is set to function in bridge mode.
LED viewing portal