User's Manual

User Guide

Antenna mount installed on the XAP-1020

4.5.3 Connecting to the Power Source

The XAP-1020 is POE ready and supports Legacy (48v 1a), 802.3af, and 802.3at

POE injectors. A POE injector is included with the device. To apply power, simply

connect the opposite end of the Ethernet cable to which the access point is

already connected to the provided POE injector or other POE switch or injector. An

Ethernet cable length of up to 300 feet can be used. DO NOT yet apply power to

the POE injector or switch.

NOTE: Category-5, super Category-5 or Category-6 unshielded twisted

pair (CAT5/CAT5e/CAT6 UTP) cables can be used. For best

results, it is recommended that Category-6 shielded twisted pair

be used to ensure stable data transmission at highest data rates.

4.5.4 Connecting to the Internet Source

Note that the Luxul device is not a router and in most installations will be con-

nected to a Router or Switch in order to deliver Internet access. To do so, connect

the POE injector (or switch) to the desired Internet source using another Ethernet

cable. Be sure the source device is powered off.