User's Manual

luxul.com | 357 South 670 West | Suite 160 | Lindon, UT 84042 | p: 801-822-5450 | f: 801-822-5460
User Guide
11
Status Indicators:
The XAP-1020 has four LEDs that can be seen through the viewing portal. With
the XAP-1020 front-facing, LEDs are as follows when viewed left to right: 1) Bridge
Mode (Green); 2) WLAN Status (Blue); 3) LAN Link/Activity (Amber); and 4) Power
(Green).
The following table describes the LED functionality:
Indicator Name Description
Bridge Mode
On Bridge Mode is enabled
Off The AP is in default “Access Point” mode.
WLAN Status
On The wireless radio is active and wireless
access is enabled an active connection to the
internet
Off The wireless radio is not active and wireless
access is disabled
LAN Link/Activity
On There is an active Ethernet connection
Flashing Indicates Ethernet activity
Off There is no active Ethernet connection
Power
On The power is on
Off No power, check power connections
At startup, the Green Power LED will stay on while the amber LAN Link light
flashes. The blue LED will come on once the XAP-1020 radio is active.
Reset Button:
The Reset button is used to clear the current settings of the XAP-1020 and restore
factory default settings.
To Restore the Default Settings: With the XAP-1020 powered on, press and hold
the Reset button for 10 seconds. When the Power LED comes on again, release the
reset button. The XAP-1020 will be set to factory defaults.
CAUTION: Pressing and holding the Reset button will remove any
custom configurations done to the XAP-1020.
4.4 Environmental Requirements
X
Ethernet cable to provide Power and Data to the XAP-1020.