User's Guide

Shock-WAV SiGnAl BooStER USER GUidE
7
4 - INSTALLATION PROCEDURES
NOTE: The combination of the Motorola AP-5131 and the Shock-WAV Wi-Fi
Signal Booster requires professional installation. Please contact Luxul
Wireless for more information.
4.1 ATTACHING SHOCK-WAV WI-FI SIGNAL BOOSTER TO THE MOTOROLA AP-5131
Shock-WAV Wi-Fi Signal Boosters are typically connected between the AP-5131 and the stock
antenna. For better coverage, use Luxul Wireless X-WAV antennas. A list of certified antennas
can be found in section 3.5.
NOTE: The primary and secondary radio ports are identified by dots over
the “RADIO” label. One dot for the primary port, and two dots for
the secondary.
21
Remove the stock antenna (Figure 1)
1 from your AP-5131’s primary
“RADIO 1” port (Figure 1)
2.
(Consult your AP-5131’s
documentation for more
details on the radio ports).
Figure 1
Using the included N-Male to RP-SMA-Female adapter (Figure 2) 4, connect the AP-5131 stock
antenna (Figure 2)
5 to the Shock-WAV Wi-Fi Signal Booster. Be sure to connect the adapter
to the side of the Signal Booster labeled Antenna
(Figure 2) 6.