User's Guide

Shock-WAV SiGnAl BooStER USER GUidE
13
Power Supply: Use only a Luxul approved power supply output rated at 48VDC and minimum
0.25A. The power supply shall be Listed to UL/CSA 60950-1; and certified to IEC60950-1 and
EN60950-1 with SELV outputs. The device can also be powered from a compliant POE source.
Use of alternative power supply will invalidate any approval given to this device and may be
dangerous.
6.2 RF EXPOSURE GUIDELINES
Safety Information: The device complies with internationally recognized standards covering
human exposure to electromagnetic fields from radio devices.
Warning: Exposure To Radio Frequency (RF) Radiation:
• The radiated output of this device is below the FCC radio frequency exposure limits.
Nevertheless, the device should be used in such a manner that the potential for human
contact during normal operation is minimized.
• The end user must avoid any extended human RF exposure directly in front of the Model
SWM-1000-I, up to a distance of 20cm, when unit is switched on.
• When servicing the equipment and selecting a location for the antennas, it is important
to note that a minimum distance of 20cm is required between personnel and the Model
SWM-1000-I antennas to comply with the radio frequency exposure limit.
• The antenna used for this transmitter must be installed to provide a separation distance
of at least 20cm from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter.
• The following safety precautions should be observed:
− Do not touch or move the antenna while the unit is transmitting or receiving.
− Do not hold any component containing the radio such that the antenna is very close or
touching any exposed parts of the body, especially the face or eyes, while transmitting.
− Do not operate the radio or attempt to transmit data unless the antenna is connected;
this behavior may cause damage to the radio.
Remote and Standalone Antenna Configurations: To comply with FCC RF exposure require-
ments, antennas that are mounted externally at remote locations or operating near users
at stand-alone desktop of similar configurations must operate with a minimum separation
distance of 20 cm from all persons.
6.3 RADIO FREQUENCY INTERFERENCE REQUIREMENTS—FCC
This equipment has been tested and found to comply with the limits for a Class B digital de-
vice, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable pro-