Data Sheet

Confidential and Proprietary of Luxshare-ict Electronic Technology (KUNSHAN) Ltd. ， which are not permitted to
disclose to others and shall not be distributed, reproduced, or disclosed
LS005ONWCS
Datasheet
8.2 Antenna used
Antenna Type Max. Antenna Gain
BT PCB Antenna 3.21dBi
BLE PCB Antenna 3.21dBi
2.4G Wi-Fi PCB Antenna 3.21dBi
5G Wi-Fi
PCB Antenna U-NII-1: 3.35dBi
U-NII-2A: 3.71dBi
U-NII-2C: 3.83dBi
U-NII-3: 3.08dBi
8.3 Labelling Instruction for Host Product Integrator
Please notice that if the FCC identification number is not visible when the module is installed inside
another device, then the outside of the device into which the module is installed must also display a
label referring to the enclosed module. For FCC, this exterior label should follow “Contains FCC ID:
2A2EX-LS005”. In accordance with FCC KDB guidance 784748 Labeling Guidelines.
§ 15.19 Labelling requirements shall be complied on end user device. Labelling rules for special
device, please refer to §2.925, § 15.19 (a)(5) and relevant KDB publications. For E-label, please
refer to §2.935.
8.4 Installation Notice to Host Product Manufacturer
The OEM integrator is responsible for ensuring that the end-user has no manual instruction to
remove or install module.
The module is limited to installation in mobile application, a separate approval is required for all
other operating configurations, including portable configurations with respect to §2.1093 and
difference antenna configurations.
8.5 Antenna Change Notice to Host manufacturer
If you desire to increase antenna gain and either change antenna type or use same antenna type
certified, a Class II permissive change application is required to be filed by us, or you (host
manufacturer) can take responsibility through the change in FCC ID (new application) procedure
followed by a Class II permissive change application.