Light Hotspot USER MANUAL (Draft)
Contents 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. Introduction............................................................................................................................. 3 Network Systems .................................................................................................................... 3 Specifications .......................................................................................................................... 4 I/O Description ........................................
1. Introduction The system is a communication device that is based on the SEMTECH SX1302/SX1250 to provide LoRa functionality of the Light Hotspot. This document intends to describe its hardware, mechanical and software specifications. 2. Network Systems This Light Hotspot collects packets from LoraWAN compatible end nodes. Received packets will be forwarded to the Network and Application servers via Internet.
3. Specifications Category Item Specification Processor MIPS24Kec, 580MHz Memory (RAM/Storage) DDR2 128MB / Flash 32MB Max. TX Power Conducted, 27 dBm @ 915.5MHz RX Sensitivity Conducted, -141 dBm @ SF=12/BW125 Ethernet 10/100M USB type A USB 2.0 x 1 Power, USB type C 5V input with Serial port LoRa I/O LED X 2 (Orange / Blue) Button X1 AC/DC adaptor 100~240V / 5V 2A LoRa Antenna External, Omni, 3.
4. I/O Description 5.
. User Guide Take out the power adapter and antenna from the package. Insert the antenna to the Lora antenna SMA port and tighten the connector. To power on the device, connect the USB Type C plug to the gateway USB Type C port, then connect AC plug to 100240V wall socket.
. Product Outline Dimension 8.
9. Light Hotspot Installation There are two ways to install Light Hotspot: Standard setting: To place Light Hotspot on a flat surface and adjust antenna to an upward position. Figure A. Standard setting Wall mount setting: Drill two holes spacing 44 mm on the wall, plug in expansion pipes, fasten the screws, and mount Light Hotspot on the wall. Figure B.
Notes: Please avoid dropping to avoid any damages during installation. Light Hotspot is intended for indoor usage. It is best to place in a dry, less dust, and ventilated area. Please avoid moist and raining areas. For best antenna performance, Light Hotspot should be placed close to window and avoid metallic objects. Warranty will be void if the product void label is tampered.
. FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
