Installation Guide

PARTS

JUNCTION BOX

ANTI-GLARE DOWNLIGHT

SPRING CLIPS

CONNECTOR

LIMITED WARRANTY

The warranty applies to the product from the original date of purchase for

three (3) years against manufacturing defects. The owner must provide a copy

of the original proof of purchase. The manufacturer’s obligation under this

warranty is limited to repairing or replacing the component. It is not related in

any way to the cost of the connection, the installation of the replacement parts

or cost of transport.

• DO NOT MODIFY THIS FIXTURE. ANY MODIFICATIONS MAY RENDER THE

PRODUCT UNSAFE AND VOID WARRANTY.

• THIS PRODUCT IS SUITABLE FOR DAMP LOCATIONS

FIXTURE INSTALLATION:

1. Turn power OFF from the electrical panel prior to installation.

2. Determine the location for installation and cut the ceiling hole in accordance with

cut-hole dimensions. Refer to CUTOUT size. (Fig. 1)

3. Open the junction box cover and remove the appropriate knockout(s) on the side panel

(Fig. 2)

4. Insert the electrical supply cable through the knockout and secure with a cable

connector (sold separately).

5. Using quick-connect push-in terminals, connect the ground wire to the green wire

terminal; black wire to black wire terminal; white wire to white wire terminal. (Fig. 2)

6. Place all wiring and connections back into the box and close the cover. Connect the

driver to the light panel.

7. Insert Junction box through the mounting hole. (Fig. 3)

8. Push spring-loaded clips on the ﬁxture upwards and insert ﬁxture base into the mounting

hole. Release the clips and ﬁxture will be pulled flush to the ceiling. (Fig. 4)

FIG. 1

FIG. 2

FIG. 3

FIG. 4

TURN THE POWER OFF FROM ELECTRICAL PANEL BEFORE

INSTALLATION OR MAINTENANCE.

3 CCT

SWITCH

2.24”

2.16”

3.14” X 3.14”

2” CUTOUT DIAMETER: 2.55”

732-882-1500

luxrite.com

LR23277

2” REGRESSED SQUARE SMOOTH TRIM – 3CCT SELECTABLE