User Manual

Spot On/O & Cycle Modes: Press and release the button on the
right of the headlamp to turn spotlight on. Press button
repeatedly to cycle through modes (Spot High/Spot Low).
High+ Mode: Press and hold the right button for 2 seconds to
turn on High+ Mode.
Flood On/O & Cycle Modes: Press and release the button
on the left of the headlamp to turn ood light on. Press
button repeatedly to cycle through modes
(High White/LowWhite/Green/Red).
Strobe: From any mode, press and hold the left button for 2
seconds to switch to Strobe mode.
USER MANUAL
Multi-color LED Headlamp
LP323
Operation Instructions
Durable ABS and rubberized compact design
LPE optics, Multi-color COB LED area light
Dual button intuitive mode selection
Non-slip adjustable headband
IPX4 waterproof rating
Batteries included (3 AAA)
Features
14725 S Porter Rockwell Blvd Ste C
Bluffdale, UT 84065
luxpro.com
866.553.8886
Battery Replacement
The LP323 has a Limited 1-Year Warranty Against Manufacturer’s
Defects from time of purchase.
For warranty claims please contact us by calling 801-553-8886 or
sending an email to [e-mail]
Product Warranty
3
AAA
Batteries
High White
High+
ANSI/PLATO FL1 STANDARD
85 lm
300 lm
LUMENSMODES
5h 30m
3h
RUN TIME
20m
85m
High Spot
220 lm
40m
BEAM
DISTANCE
Green
51 lm
7h 30m
5m
4h
Spot Modes
Flood Modes
Low Spot
50 lm
6h
20m
Low White
34 lm
8h 30m
5m
Red
15 lm
3h
1m
The LP323 uses 3 AAA batteries.
To replace the batteries, rst locate the two plastic tabs on the
sides of the headlamp. Gently push tabs outward using both
thumbs to separate the battery cover from the main headlamp
housing. Remove the old batteries and insert new batteries
according to the (+/-) symbols in the battery tubes. For best
results, we recommend using brand new alkaline batteries that
are the same voltage and brand.
To re-attach the battery cover, line the plastic tabs on the main
housing up to the battery cover taking note to match them in
proper orientation (the LUXPRO logo on the battery cover should
line up with the On/O buttons on the main housing).
Gently press the two sides together until they click into place.
Check that the battery cover is secured by gently tugging on the
headlamp straps while holding the main housing rm.
If you know it will be a while between uses, we suggest removing
the batteries from the head lamp and storing it in a dry, protected
place.