Student-M (Manual Height Adjustable Student Desk) Assembly Guide Top with plastic drawer attached Left leg frame Right leg frame Upper support bar Left leg frame Extension Right leg frame Extension Lower support bar Lower shelf for book storage 10/27/16 1/6
Wood screws to secure the top to the frame QTY 16 Set screws for leg height adjustment Set screw hex wrench QTY 4 Counter sunk screws QTY 8 Assistance Required Support bar screws QTY 4 Support bar washers QTY 4 Screwdriver needed Step 1: Gather parts B, C, G, N, P, and L. Install the support bar to the left and right leg frame using the support bar screws and washers and the hex wrench.
Step 2: Gather parts H, M, and L. Install the lower shelf with the counter sunk screws and the hex wrench. Step 3: Gather parts D, E, F, N, P, L. Step 3A: Install D, E into the base frame.
Step 4: Gather parts H, M, and L. Place the top upside down on a protected surface.
Step 6: Determine what height you need. Note that you can always adjust later to fit your needs. Note the lowest and tallest setting 26” through 42”. There are adjustment points at 1” increments to adjust your height. When you reach your desired height, set screws lock it in position.
Step 7: Gather parts K and L. With assistance, pull the desk to the desired height, and secure in place with the set screws and set screw hex wrench.
