Tribeca Shoe Closet
Before starting Prepare the room before starting the assembly, leaving it completely clean and the area in good condition to start the work. Use the cardboard of the packaging and the foam sheets protection to separate and support the parts removed from the boxes. Dimension: W: 32.67" H: 50.59" D: 15.
FRONT VIEW REAR VIEW 01 04 08 06 03 09 05 06 02 08 09 06 07 07 07 PART 01 02 03 04 05 06 07 08 09 DESCRIPTION TOP RIGHT SIDE FIXED SHELF LEFT SIDE BASE BACK COVER FEET SUSPENDED SHELF DOOR QUANTITY 01 01 01 01 01 03 04 02 02 HARDWARE A 04x B 04x C 08x D 04x E 04x F 34x G 02x H 08x I 02x J 24x K 02x L 01x E U GL M 01x N 02x O 01x P 04x 2 Q 01x
STEP 1 B B 08x H 01 H B H B H B 04 H H H 04x 02 H H - Insert the hardware (B) on the pieces (01, 02 and 04). - Insert the accessory (H) on the parts (02 and 04). STEP 2 A 02x A 01 C C A 02x 02 03 - Join the parts (01 and 02) with hardware (A). - Fix the part (03) into part (02) with a bolts (C). STEP 3 A C A 02x 01 A 04 03 C C 05 C - Join the parts (04 and 01) with the hardware (A). C - Fix the part (03) into part (04) with a bolts (C).
STEP 4 F 34x 06 06 06 K 02x - Fix back cover (06) with nails (F). - Insert the hardware (K) among pieces (06). STEP 5 P+E USE THE GLUE (L) BEFORE FASTENING THE FEET (07). 07 L P+E 05 P 04x 07 07 E 04x 07 07 - Fix the feet (07) under the base (05), using bolts (P). - Apply the plastic covers (E) on top of the bolts (P) STEP 6 08 - Insert the shelfs (08) shawn in image.
STEP 7 D+2J D+2J 02x I 09 09 I G D+2J G D+2J J 02x - Fix the hinges (D) in the doors (09) with bolts (J). 08x D 04x - Fix the handles (I) in the doors (09) with bolts (G). STEP 8 4J 16x 04 J 09 02 4J 09 - Fix the hinge connectors (D) of the doors (09) in the parts (02 and 04) with a bolts (J), taking the marking as reference for correct positioning. STEP 9 WALL Attention! This step is very important! You need to attach the Shoe Closet on the wall to avoid any tip over risk.
M 08 Pass the hardware M through the hole of the part 08 as showed in the figure above. You will need a pencil to mark where you should drill the wall with a 5/16" drill bit to put in the hardware Q. Q wings *press the wings of the hardware Q wings to put in the hole that you drilled in the wall. Hardware P, plugged in the wall. Q M Screws the hardware O passing through the hardware M until the hardware Q. N N O Screws the hardware N passing through the hardware M and fit in below the piece 01.