Tribeca TV Panel 53.
Before starting Prepare the room before starting the assembly, leaving it completely clean and the area in good condition to start the work. Use the cardboard of the packaging and the foam sheets protection to separate and support the parts removed from the boxes. Dimension: W: 53.94" H: 40.55" D: 7.
FRONT VIEW REAR VIEW 03 06 05 04 04 02 01 PART 01 02 03 04 05 06 DESCRIPTION LOWER PANEL TOP PANEL PANEL SUPPORT BACK SUPPORT SHELF WALL SUPPORT QUANTITY 01 01 01 02 01 01 HARDWARE A 12x B 08x E 01x D F 02x C 02x G 03x E U GL 2 D 01x H 06x
STEP 1 H C+4B H 02 B H C B B B C+4B 01 H - Insert hardware (H) into parts (01 and 02). 04X H - Join the panels (01 and 02) correctly aligning the edges, avoiding gaps between the parts and connect them with the steel plate (C) and bolts (B). STEP 2 A 04X A A H 03 A E A 03 USE GLUE (E) ON THE FACE CONTACT OF THE PIECE (03) BEFORE FIXING AT THE PANEL (02). H - Fix the piece (03) in the top panel (02) with bolt (A).
STEP 4 G G G 03X G H 02 05 H - Connect the shelf (05) in the top panel (02) with the bolts (G) and dowels (H). - Insert the plastic part (D) in the panel (01). D 01X STEP 5 06 With a pencil and measuring tape mark the height to fasten the part (06) on the wall. STEP 6 - Drill the wall with one twist bit drill of 1/2 inches.
STEP 7 05 06 F F 02X Toggle bolt screw F Fasten the part (06) on the wall and keep the 45° degree cut to up side. STEP 8 - Verifying all the supports you are ready to hang your TV panel on the wall.
