Full Product Manual

4
WSP05 Rev. B 04/2018Luxier USA
Installation
A. Shut o water supply at the valves.
Remove old faucet and clean the
mounting surface for installation of new
faucet.
D. Apply Teon (TPFE) tape on the
thread of the center spout brass pipe.
Use an adjustable wrench to tighten the
ttings. (NOTE: Do not overtighten the
connection.)
F. Insert hot and cold valves from under-
neath the mounting surface. Secure the
handle assemblies with the decorative
trims from top of the mounting surface.
E. Use a small hex wrench to loosen the
small setscrew on the handle. Lift up the
decorative trim handle and remove all
trim pieces.
G. Apply Teon (TPFE) plumbing tape
on both valve assemblies and shuto
valves. Attach water supply hoses with
1/2” ttings (not included) with an ad-
justable wrench. Also connect the water
hose between the handle assemblies
and the center spout. (NOTE: Do not
overtighten the connection.)
H. Use the aerator wrench to remove
the aerator. Turn on both hot and cold
handles and let the water run for about
1 minute to ush out any sediment or
debris inside the plumbing. Also check
for leaks at all connections.
I. Re-install the aerator once all con-
nections are checked. Keep the aerator
wrench for future use. The installation is
complete at this time.
B. Place spout with ange through the
center mounting hole on the mounting
surface.
C. Insert the C shaped rubber / metal
washer and locking nut on the center
spout. Use an adjustable wrench to se-
cure spout in place. (NOTE: Do not over
tighten the locking nut.)
A B C
D F
Hot
Cold
G H
E
I