Specification

4
WSP03 Rev. D 04/2020Luxir USA
Installation
A. Shut o water supply at the valves.
Remove old faucet and clean the mounting
surface for installation of new faucet.
D. Apply Teon (PTFE) tape on the thread
of the T connector and connect the water
inlet hoses to the T connector. Use an
adjustable wrench to tighten the ttings.
Do not overtighten the connection.
(IMPORTANT: The black hoses are longer
by design to accommodate wider installation.
For narrower installation, it is strongly
recommended to loop the hoses around
before connecting to the T connector to
avoid any kinks. Turn the T connector at an
angle will make connecting the black hoses
easier.)
F. Apply Teon (PTFE) tape on the thread in
a counter-clockwise direction.
Connect water supply hoses with 1/2” IPS
connectors to valves. Make sure the lter
is properly seated between the hose and
the brass pipe. Use an adjustable wrench
to tightening the hoses. Use a second
wrench to anchor the tting. Please do not
overtighten the ttings.
E. It is highly recommended to ush the
water lines before connecting the water
supply hoses (not included) to the faucet.
Place a water bucket under the cabinet, with
both water supply hoses inside the bucket.
Slowly turn on the valves and let water run
for about 45 seconds.
G. Turn on water supply and allow the unit
to run for about 1 minute while check for
leaks at all connections.
(Note: Sediments or mineral buildup will
clog the lters and decrease water ow. It is
recommended to clean the lters regularly to
maintain proper water ow to the faucet.)
B. Place spout with ange through the center
mounting hole on the mounting surface.
Secure spout with metal washer and metal
nut. Once the spout is secured. Push the
T connector onto the mounting tube until
it snap into place. (Caution: The 2 rubber
o-rings must be seated properly in the
grooves on the mounting tube.) Lock the
T connector in place by rmly inserting the
locking pin.
C. Slide hot and cold water handle / valve
through mounting holes. Make sure the
connecting hoses are installed toward the
center spout. Handles should point outward
in o position. Secure the handles with metal
washers and mounting nut. Hand tighten
the nut onto the valve and secure it by
tightening the screws
A
B C
D F
G
E
01. Handle
02. Setscrew
03. Flange
04. Bonnet
05. Cartridge
06. Valve Body
07. Filter
08. Metal Washer
09. Mounting Nut
10. Screw
11. Aerator
12. Spout
13. Flange
14. Mounting Tube
15. O-Ring
16. Metal Washer
17. Mounting Nut
18. T Connector
19. Locking Pin
20. Water Supply Hose
* non-removable
01
11*
12
13
14*
15
20*
16
02
03
04
05
06
07
08
09
10
17
18
19