Installation & Assembly

4
WSP03 Rev. C 05/2019Luxier USA
Installation
A. Shut o water supply at the valves.
Remove old faucet and clean the mounting
surface for installation of new faucet.
D. Apply Teon (PTFE) tape on the thread of
the T connector and connect the water inlet
hoses to the T connector. Use an adjust-
able wrench to tighten the ttings. Do not
overtighten the connection.
F. Apply Teon (PTFE) tape on the thread in
a counter-clockwise direction.
Connect water supply hoses with 1/2” IPS
connectors to valves. Make sure the lter is
properly seated between the hose and the
brass pipe. Use an adjustable wrench to
tightening the hoses. Use a second wrench
to anchor the tting. Please do not over-
tighten the ttings.
E. It is highly recommended to ush the
water lines before connecting the water
supply hoses (not included) to the faucet.
Place a water bucket under the cabinet, with
both water supply hoses inside the bucket.
Slowly turn on the valves and let water run
for about 45 seconds.
G. Turn on water supply and allow the unit
to run for about 1 minute while check for
leaks at all connections.
(Note: Sediments or mineral buildup will
clog the lters and decrease waterow. It is
recommended to clean the lters regularly to
maintain proper waterow to the faucet.)
B. Place spout with ange through the center
mounting hole on the mounting surface.
Secure spout with metal washer and metal
nut. Once the spout is secured. Push the T
connector onto the mounting tube until it
snap into place. (Caution: The 2 rubber o-
rings must be seated properly in the grooves
on the mounting tube.) Lock the T connector
in place by rmly inserting the locking pin.
C. Slide hot and cold water handle / valve
through mounting holes. Make sure the
connecting hoses are installed toward the
center spout. Handles should point outward
in o position. Secure the handles with metal
washers and mounting nut. Hand tighten the
nut onto the valve and secure it by tighten-
ing the screws
A
B C
D F
G
E
01
12
13
14
15
16
17
22
18
02
03
04
05
06
07
08
09
10
11
19
20
21
01. Handle (RP428S21)
02. Setscrew (RP415A71)
03. Flange (RP428S22)
04. EVA Washer (RP428S65)
05. Bonnet (RP428S26)
06. Cartridge (RP428S43)
07. Valve Body
08. Filter (RP428S80)
09. Metal Washer (RP428S73)
10. Mounting Nut (RP428S06)
11. Screw (RP428S75)
12. Aerator (RP428S73)
13. Spout (RP428S01)
14. Flange (RP428S23)
15. EVA Washer (RP428S65)
16. Mounting Tube (RP428S73)
17. O-Ring (RP428S57)
18. Metal Washer (RP428S76)
19. Mounting Nut (RP428S17)
20. T Connector (RP428S08)
21. Locking Pin (RP428S79)
22. Water Supply Hose (RP428S67)