Specification

5 SS-B01 Rev. F 072021

Luxier

Installation (Cont.)

6. Remove the handle and the escutcheon plate and

set them aside. Remove the threaded nipple (12) and

the stem extension (11) from the valve body. Use a

hacksaw to trim the threaded nipple (12) and valve

stem extension (11) based on the measurement taken

in gure E1 as shown in gure F. (NOTE: Do not trim

the stem extension (11) and threaded nipple (12)

directly on the cartridge because it will damage the

cartridge.

Trim the pieces separately, do not trim both parts at

the same time. It is best to cut o only small amount

of the brass stem and test t the handle.)

7. Figure G. Re-install the threaded nipple (12) and

stem extension (11) assembly to the valve body.

Carefully slide the escutcheon plate onto the valve and

attach the handle assembly.

8. Slide the ange onto the shower arm and apply

PTFE tape to both ends of the shower arm. Attach

the shower arm to the pipe and slide the ange onto

the wall. Attach the shower head as shown in Fig. H.

(NOTE: Do not over tighten the connections.)

9. Turn on the water and check for leaks at all

connections. The installation is now complete.

5. Remove and discard the protective sleeve (15) and cover (13) from the valve. Slide the escutcheon

onto the valve as shown in Fig. E. Place the handle assembly on the stem extension and turn the handle

clockwise to install the handle. If there is a gap when the handle is attached to the valve measure and

write down the distance of the gap between the handle and the escutcheon plate as shown in Fig. E1.