Measurement Guide

SS-B01Rev. D 012019Luxier

Installation (Cont.)

7. Re-install the threaded nipple (12) and stem (11) assembly to the valve body. Carefully slide the

escutchron plate onto the valve and attach the handle assembely shown in gure G.

8. Slide the ange (3) onto the shower arm (2) and apply PTFE tape to both ends of the shower arm.

Attach the shower arm to the plumbing and slide the ange on the wall. Attach the shower head (1) as

shown in Fig. H. (NOTE: Do not over tighten the connections.) The installation is now complete.

5. Remove and discard the protective sleeve (15) and cover (13) from the valve. Slide the escutcheon

onto the valve. Attach the handle (18) as shown in Fig. E. Place the handle assembly on the stem

extension (12) and turn the handle clockwise to install the handle. If there is a gap when the handle

is attached to the valve measure and write down the distance of the gap between the handle and the

escutcheon plate as shown in Fig. E1.

6. Remove the handle and the escutcheon

plate and set them aside. Remove the

threaded nipple (12) and the stem (11) from

the valve body. Use a hacksaw to trim the

threaded nipple (12) and valve stem (11)

based on the measurement taken in step

5 gure E1 as shown in gure F. (NOTE:

Trim the pieces separately, do not trim both

parts at the same time. It is best to cut o

only small amount of the brass stem and

test t the handle.) (NOTE: Do not trim the

stem (11) and threaded nipple (12) directly

on the cartridge because it will damage the

cartridge)