Measurement Guide

SS-B01Rev. D 012019Luxier

Installation

1. Position valve body in wall. It is recommended the valve to be about 48” above the oor and shower

outlet to be about 30” above the valve (Fig. A1) The nished wall should be set between the markers on

the temporary protective cover. The recommended depth is 2 11/16” to 3 7/16”. (Fig. A) Make sure the

UP outlet is pointed upward. (Fig. B)

NOTE: Valve access hole on the wall should be 6” in diameter and outlet hole for shower arm is about 1

1/4” in diameter.

2. Connect the valve to the plumbing with proper ttings. Perform a dry t before soldering pipes to the

valve. (Fig. C)

WARNING: Exposure to high temperature will damage the cartridge (9) and stop valves (7, 8). Remove

these parts before soldering.

48”

30”

* Drawing not to Scale

3. After the pipes are soldered, install the stop valves (7, 8), cartridge (9), stem (11), and threaded

nipple (12) back onto the valve body.

4. Pressure test and ush the valve. NOTE: Pressure must be approximately equal on both hot and cold

side for the valve to function properly. (Fig. D)

• Install a 1/2” iron pipe plug (not included) on the shower outlet.

• Turn the valve to ON position and check all connections for leaks for about a minute.

• Turn the valve to OFF position after pressure test. Make sure the pipes are free of debris or

sediments and remove the 1/2” plug.

Finished Wall

Protective Cover

Recommended

2 11/16” - 3 7/16”

Mounting Hole

WARNING: Remove all parts before solder

Stop Valve (7, 8)

Cartridge (9)