Installation Guide
Luxier SP24-SS Rev. A1 0120167
Installation
1. Install hand shower connector and at-
tach PVC tubing to complete the connec-
tion. 
2. Mark the positions of the 2 brackets on 
the wall and set a side the panel. (NOTE: 
The distance between the two brackets 
should be 770mm or 30.31”)
770mm
30.31”
1”
3. Using a drill with a tile bit, drill the hole 
slowly into the tile. Do not drill into any pip-
ing or wiring in the wall. Insert the anchors 
into the wall. (NOTE: Before installing the 
wall anchors, use a small piece of painters 
tape or masking tape over the drill area. 
This will prevent damages to the tile)










