Installation Guide

Luxier SP22-SS Rev. A2 0920168
Installation (cont.)
4. Apply thread sealant tape to the thread-
ing on the shut o valves before connect
both hot and cold water supply hoses to
the valves. Turn on the valves and check
all connections for possible leaks.
5. Hang the unit on the wall to complete the
installation. Make sure the unit is seated
properly. Apply silicon sealant on left and
right sides of the shower panel. (NOTE: do
not seal the bottom of the panel, this will
allow any possible future leaks to drain out
the panel)
6. Connect hand shower hose to the main
panel body. Attach the hand shower to the
hose. (NOTE: Install the rubber washer to
prevent leak.)