Installation Guide

Luxier SP22-CEC Rev. A1 0320207

Installation

800mm

31.5”

1. Install hand shower cradle (1) to the shower panel by

installing the rubber washer (2) and the locking nut (3) and

attach white plastic hose tube connector (5) with PVC tubing

to complete the connection. (NOTE: Make sure the silicon

gasket (4) is seated properly inside the connector.)

2. Lift the panel to determine the proper height and

placement. It is recommened to aim the top horizontal body

jet to the chest area for optimal showering experience. Mark

the positions of the 2 brackets on the wall and set a side the

panel.

(NOTE: The distance between the two brackets should be

800 mm or 31.5”)

1”

3. Using a drill with a tile bit, drill the hole slowly into the tile.

Do not drill into any piping or wiring in the wall. Insert the

anchors into the wall.

(NOTE: Before drilling the tiles, use a small piece of painters

tape or masking tape over the drill area. This will prevent

damages to the tiles)

4. Secure the mounting brackets to the wall with the screws.