Installation Guide

Luxier SP06-SS Rev. A3 0920168
Installation (cont.)
Lift the panel to determine the proper height and placement. It is recommened to aim
the top horizontal body jet to the chest area for optimal showering experience.
444mm
17.48”
4. Mark the positions of the 2 brackets on the
wall and set a side the panel. (NOTE: The
distance between the two brackets should be
444 mm or 17.48”)
5. Using a drill with a tile bit, drill the hole
slowly into the tile. Do not drill into any piping
or wiring in the wall. Insert the anchors into
the wall. (NOTE: Before installing the wall
anchors, use a small piece of painters tape
or masking tape over the drill area. This will
prevent damages to the tile)
1”
6. Secure the mounting brackets to the wall.