Installation Guide

Luxier SP06-SS Rev. A3 09201610
10. After the excess hose has been trimmed.
First slip compression nut (C) and the com-
pression ring (B) onto the PVC hose (D). In-
sert the elbow connector (A) into the hose.
Push the compression ring (B) up toward the
end of the hose as far as possible. Tighten
the compression nut (C) (NOTE: Do not over
tighten the nut as it may damage the seal and
causes leaks)
11. Wipe the surrounding surface around the
pipe free of dirt and debris. Peel o the adhe-
sive backing of the cover base (A) and press it
rmly against the wall to ensure a tight bond.
Apply some PTFE tape on the pipe threading.
Connect the main water supply hose assem-
bly to the pipe. (NOTE: Do not over tighten
the nut as it may damage the seal and causes
leaks) Once the connection is made, install
the cover over the elbow connector.
A
B
C
D
A
B
Installation (cont.)
12. Connect hand shower hose to the main
panel body. Attach the hand shower to the
hose. (NOTE: Install the rubber washer to
prevent leak.)